camber的例句大全

This provides an increased damping rate and allows a slight reduction in camber angle.

这样就增加了减震度,并且可以稍微减少外倾角.

A key point on the construction technology, analysis of the template, frame strength, rigidity, stability, and calculation results based on pre-degree camber settings are discussed.

阐述了关键点施工工艺，计算分析了模板、支架的强度、刚度、稳定性，并根据计算结果度设置预拱度进行了探讨。

The Precision Measurement of Screw Camber Varying with Pitch Pushing for Precision PRECISION STEEL TUBES Thread Milling

变螺距螺纹曲面的精密测量

It is disadvantageous to thrust characteristic through increase camber of airfoil.

而扑动翼翼型弯度的增加不利于推力特性的提高。

Tighten lock nut from camber eccentric to the prescribed tightening torque tightening torques for rear axle.

将外倾角偏心装置的锁紧螺母紧固至规定的拧紧力矩后轴的拧紧力矩。

FEA of belt deformation of radial tire on camber rolling state

侧倾滚动轮胎带束层受力状态有限元分析

A Study on Contact Patch of Tire with Camber and Sideslip

外倾和侧偏联合作用下轮胎接地印迹研究

While studying for a fine arts degree at Camberwell College of Art she was also apprenticed to a studio in Surrey.

在坎伯韦尔艺术学院（Camberwell College of Art）修读美术时，胡尼扬还在萨里（Surrey）的一个工作室当学徒。

Strata section plane plotting based on mobile camber fitting using layered interpolation

基于移动曲面拟合法分层插值的地层剖面绘制

A model of a "embryo" bubble growing up a visible bubble in the bubble camber is established.

建立了气泡室中胚胎气泡成长为可见气泡模型。

Optimization Analysis of the Internal Force of Hangers in Camber Composite Bridge

梁拱组合式桥梁吊杆内力的优化分析

A Probe into Dynamic Formation Method of Geometric Camber by VB

几何曲面VB动态生成方法浅探

Establishment of Expert Knowledge of Armhole Curve's Camber of Shaped Sub-basic Pattern

变形亚基本纸样袖窿弧线内凹量专家知识的建立

The automatic camber control system of the line is introduced completely in the paper.

本文将对该生产线的自动凸度控制系统作全面详细的介绍.

The tilt of the wheel ( camber ) is measured in degrees and is adjustable on many vehicles.

该轮 ( 弯度倾斜 ) 是衡量度,是许多车辆可调.

A taper has two sides, the underside is a circle, the flank is a camber.

结论:圆锥有两个面, 底面是一个圆形, 侧面是一个曲面.

The front subframe is modified for extra camber and castor.

前副车架被修改为额外拱形和蓖麻.

Application of low Mooney viscosity, non pollution type NBR to thin camber sponge rubber was studied.

研究低门尼粘度 、 非污染型丁腈橡胶在薄型曲面海绵胶料中的应用.

Camber line won " ts do orthogonal arc tooth wimble gear. "

中心线 不成 直角的弧齿锥齿轮.

The measures for improving wear of camber for lockup were proposed.

针对锁紧弧面的磨损提出了改善措施.