Tourism higher education is a uniquely professional education in which industry demand is viewed as a base for running a school, motive force and the starting point.

The base of running digital manufacturing system is exact data gathering of tool, equipment, materiel and producing.

数字化制造系统的运行是以准确高效的刀具、设备、物料与在制品等资源的数据采集为基础。

Analysis of the Hitting Technique of Chinese Talent Women Softball Players throwing, base running and stealing bases.

我国优秀女子垒球运动员击球动作技术分析个人的基本技术包括击、投、守、场内传球、跑垒和偷垒。

For the traditional Doherty power amplifier, the current of the peaking amplifier could not get to the maximum allowable level that the load modulation of both amplifiers was unable to achieve the optimized impedance at the maximum output and resulted in the efficiency degeneration because its low bias.

对于传统Doherty放大器，由于峰值放大器偏置的原因使其在最大输出工作状态时，无法达到最大电流而导致两个放大器的输出端无法实现最佳负载调制，造成整体效率下降。

The allowable stress number, load, geometry parameters and life have the most significant effects on pitting resistance rating results;

试验齿轮的应力修正系数、载荷和几何参数对弯曲强度计算结果的影响较大。

Research on the method for calculating allowable external pipe load applied to brazed aluminum heat exchanger based on limit analyse

基于极限分析的铝板翅式换热器封头许用接管载荷计算方法研究

Calculation Method of Allowable External Pipe Load Applied to Brazed Aluminum Heat Exchanger Header and Its Application

板翅式换热器封头许用接管外载荷计算方法及应用

The points out that the following should be followed to reduce tire wear: ensure tire normal air pressur and normal allowable tire load, assure optimum front wheel alignment parameters, design rational steering mechanism, increase integral torsional rigidity of the truck and its body.

指出，为减少轮胎磨损，应从以下几方面着手：保证轮胎正常行驶气压及允许裁荷、寻找最优前轮定位参数、设计合理的转向机构、提高整车和车箱的整体扭转刚度。

By analyzed interactions of combined limit pipe load components, simplified check formula for pipe load strength are put forward and the calculation method of relevant allowable pipe load values based on shell finite element analysis is presented as well.

通过对组合极限接管载荷分量相互关系的分析，提出了接管载荷强度验算简化公式和以壳结构有限元应力分析为基础的许用接管载荷计算方法。

Applying strength theory, established the strength conditions of steel wire, rubber, and the shear strength condition of steel wire and rubber, and obtained the maximum allowable pull-out load of anchor.

应用强度理论，建立了锚杆体中钢丝、橡胶的强度条件及钢丝与橡胶的剪切强度条件，得出锚杆的最大许用拉拔载荷。

Make the anchor ground-based test, study the impact of inner press on the allowable pull-out load of anchor and the resistance, make seal test and working stability test and failure test.

进行地面试验，研究内注压力对锚杆许用拉拔载荷和抗剪切力的影响，以及锚杆密封性、承载稳定性试验和失效试验。

Maximum permissible amount ( MPA) The model is known as the maximization of total allowable waste load, subject to meeting water quality standards at checkpoints along the river.

模型以总的允许排污量最大为目标函数，流域的水质控制点达标为约束条件。

The cause of externally applied pipe load to brazed aluminum heat exchanger and the necessity of calculating allowable pipe load are analyzing.

分析了板翅式换热器封头接管外载荷产生的原因和进行许用接管载荷计算的必要性。

Influence of the characteristic value of stirrup content in boundary elements on allowable axial load ratio for concrete structural walls

边缘约束构件配箍特征值对剪力墙轴压比限值影响的分析

Calculation and Determination of the Allowable Eccentric Load for RC Bridge Piers

钢筋混凝土桥墩容许偏压荷载的计算确定

The study on the allowable axial load ratio of concrete shear wall without confined boundary elements

无约束边缘构件混凝土剪力墙的轴压比限值研究

Water environmental capacity and allowable water load capacity of the lake in the region of plain water network

平原水网地区湖泊的水环境容量及允许负荷量

Allocation method of allowable waste load in river based on the principle of equitable interval

基于公平区间的污染物允许排放量分配方法

Conclusions can be drawn as follows: ( 1) when the prestress is bigger, the anchorage affect is greater, but the prestress must be in the limitation of the allowable load that the anchorage segment can be borne.

通过分析得出：（1）外部施加的预应力越大，在锚固体受力容许范围之内，其锚固效果越好；

The physical parameters of the resistance function are calculated with measured data, and the load-displacement curve computed by means of a non-linear mathematical model agrees with the measured one. Then the values of allowable load and permissible displacement are proposed.

该方法用非线性的土阻力数学模型，应用实测资料求出了阻力函数中反映岩土物理指标的参数，算出了与实测值相吻合的荷载-位移曲线，提出了容许荷载、容许位移的指标。

The main contents are as follows: ① Calculation methods are introduced for the allowable load height ( HA) and allowable capactity, and several HAs specified depending on the tanks with or without fire fighting devices.

主要内容是：①允许装油高度和允许装油容量，根据有消防设备和无消防设备两种情形给出计算方法，并规定了几种主要储油罐的允许装油高度H允。